Schuck 3Dthe kosher 3D print marketRequest a printSign in
Getting started

Print tip: how layers work

A printer builds one thin layer at a time. What that means for detail, speed and strength.

Schuck 3D · Nov 19, 2026 · 1 min read

Print tip: how layers work

A 3D printer draws your part one thin slice at a time, from the bottom up. Each slice is a layer.

Layer height

  • The standard on a 0.4 mm nozzle is 0.2 mm per layer.
  • Thinner layers (0.12 to 0.16 mm) look smoother on curves and letters, but take longer.
  • Thicker layers print faster and look rougher.

Layers are the weak spot

  • Each layer is melted onto the one below. That bond is weaker than the plastic itself.
  • Parts usually break along a layer line.
  • Turn the part so the pulling force runs along the layers, not across them.

Overhangs

  • Every layer has to sit on the one below.
  • Slopes up to about 45 degrees print fine.
  • Anything flatter, or hanging in the air, needs supports.

Lay a part so it is strong, then check it still looks good. Strength first.

Keep reading