Schuck 3Dthe kosher 3D print marketRequest a printSign in
Getting started

Print tip: clean the plate before you blame the printer

Most prints that come loose have one cause: a dirty plate. How to clean it and keep it clean.

Schuck 3D · Nov 19, 2026 · 1 min read

Print tip: clean the plate before you blame the printer

If a print lifts off the plate or the first layer looks messy, check the plate first. Most of the time it is just dirty.

Why it matters

  • The first layer has to stick to the plate, or the whole print fails.
  • Fingerprints leave oil on the plate. Plastic doesn't stick to oil.
  • Old glue and dust do the same thing.

How to clean it

  1. Take the plate off the printer.
  2. Wash it in the sink with warm water and a little dish soap.
  3. Rinse it and dry it with a paper towel.
  4. Hold it by the edges from now on.

Between prints

  • Wipe it with isopropyl alcohol and a paper towel.
  • Do a full wash every so often, or whenever prints start lifting.
  • Bambu Studio tells you when a plate and filament combination needs glue stick. Use it only when it asks.

Short version: wash the plate with soap, and don't touch where the print goes.

Keep reading