Schuck 3D PrintsLog in

Printing the toy menorah

MenorahOpen design →

Pick your menorah

  • Base: rounded, branches, train or flat.
  • Lights: magnetic candles that click on, or a version for real oil.
  • Candles: pick a style and colours. Silk filament gives the candles a shine.

What you need

Printing

  1. Open the file in Bambu Studio. The colours are already set.
  2. Print the base and the candles. The candles have a pause so you can drop the magnets in.
  3. When the printer pauses, press a magnet into each hole, then let it finish. The top layers close over the magnet.
  4. Check that every magnet is the right way up before you resume, so the candles stick to the base instead of pushing away.

Small magnets are dangerous if swallowed. Make sure each magnet is sealed inside, and keep loose magnets away from little kids.

For real oil

Use the oil version only with a grown-up. PLA softens with heat, so keep the flame away from the plastic, and never leave it burning alone.

As an Amazon Associate I earn from qualifying purchases. It doesn't cost you anything extra.